Insert bearing

Outer spherical ball bearing is actually a variant of deep groove ball bearing, which is characterized in that the outer diameter surface of its outer ring is spherical, which can be fitted into the corresponding concave spherical surface of the bearing seat to play the role of self-aligning. Although its basic performance should be similar to that of deep groove ball bearings, because these bearings are mostly used in relatively rough machinery, the installation and positioning are not accurate enough, the axis alignment between the shaft and the seat hole is poor, or the shaft is long and deflected. In the case of large and other, and the bearing itself is not high enough precision, and some structures are relatively rough, so the actual performance of the deep groove ball bearing of the same specification should be marked with a considerable discount. For example: the outer spherical ball bearing with top wire is used in the through shaft with large stiffness difference and large deflection. This kind of bearing has sealing rings on both sides, which can strictly prevent the intrusion of dirt. It has been filled with an appropriate amount of lubricant before leaving the factory, and it does not need to be cleaned before installation. , No need to add lubricant, when the top screw on the protruding end of the bearing inner ring is fastened on the shaft. The allowable axial load shall not exceed 20% of the rated dynamic load. Insert spherical bearings are preferably used in applications requiring simple equipment and components, such as agricultural machinery, transportation systems or construction machinery. It is mainly used to bear the combined radial and axial load mainly based on radial load. Generally, it is not suitable to bear the axial load alone. This kind of bearing can be installed with the inner ring (with a full set of rollers and cages) and the outer ring respectively. This kind of bearing does not allow the shaft to be inclined relative to the housing, and additional axial force will be generated under the radial load. The size of the axial clearance of this kind of bearing has a great relationship with whether the bearing can work normally. When the axial clearance is too small, the temperature rise will be high; when the axial clearance is large, the bearing is easily damaged. Therefore, special attention should be paid to adjusting the axial clearance of the bearing during installation and operation. If necessary, pre-interference installation can be performed to increase the rigidity of the bearing.